How to install low voltage lighting in your deck to obtain the best results. Preferred Properties Landscape Lighting designer Michael Gotowala walks us through the professional way to light up the deck with step lights, Orions and Puck Lites
Split and strip your wires. Connect 1 side of the split wire to one side of the socket. And again with the other side.
Strip and split your wire. Insert one side into slot A and the other into slot B. Do the same with multiple runs of wire.
Run your 16 G wire from post to post under the handrail. Staple up the wire every 6″ or so without stapling through the wire.
Take your 1/2″ drill bit and drill from under the hand rail up at an angle into your auger bit hole
Take your 1 3/4″ Forstner bit and drill down over your auger bit hole about 1.5″ deep. This hole allows you to tuck in your wire connections with ease.
Take your 1″ Auger bit and drill down through the top of the post to a point that is just below the hand rail.
Check the top of the post to make sure the deck light fits down far enough onto the post to allow it to be screwed in.
July 21, 2008 — DEKOR. Light the Night with innovative LED lighting, balusters & post caps from DEKOR. DEKOR’s versatile collection of coordinated building products will add beauty, ambiance, and value to your home. Quality, Craftsmanship, Value, Service, Technology, and Warranty. This video shows how DEKOR sets the bar for quality in LED lighting and railing products. DEKOR provides you with the best value for your hard earned money. We offer innovative LED lighting technology, American workmanship, high quality standards, industry leading warranties, and great customer service. DEKOR is an EnergyStar Partner. Visit our website at www.de-kor.com to learn more about our premium quality coordinating building products and LED lighting options for indoors, outdoors, decks, patios, docks, and more. Video by Ashley Scott of Iniosante Studios llc (www.iniosante.com) for DEKOR Glenbrook Displays DEKOR Products, check us out at: www.glenbrooklumber.com
Low Voltage Controls For Home Made Plasma Cutter. This shows the electrical connections of the controls for the low voltage side(secondary) of the transformer. Please note this is for informational purposes only! This device is not isolated from ground and in this current version could, under correct circumstances, cause a lethal shock. This device was tested on a dry concrete slab and show a open to ground voltage of 7.3 volts.
